Instructions / Assembly

Set-Up

Contents of Carton

Roof Enclosure

Left Door Enclosure Right Door Enclosure

Roll of Velcro Tape

Storage Bag

Figure 3-1

Tools Required

• Scissors

• Rubbing

Alcohol

3M Adhesive Promoter

Shape of roof and doors may vary based on your model, but overall installation is basically the same

PAGE 1
Set-Up Contents of Carton Roof Enclosure Shape of roof and doors may vary based on your model, but overall installation is basically the same Roll of Velcro Tape Left Door Enclosure Right Door Enclosure Storage Bag 3M Adhesive Promoter Figure 3-1 Tools Required • • Scissors Rubbing Alcohol
PAGE 2
NOTE: All references to LEFT, RIGHT, FRONT, and REAR indicate the cab enclosure position on the equipment when facing forward while seated in the operator position. 3. NOTE: The clear vinyl may be wrinkled from shipping. The wrinkles will come out within a few days. A blow dryer may be used to blow warm air onto the clear vinyl to progress the wrinkle removal. Be careful not to overheat the vinyl. Slide the roof enclosure over the top of the existing UV roof into the desired position.
PAGE 3
10. Remove adhesive backing from all the other velcro strips, and apply pressure against the mounting surface. NOTE: Using a blow dryer to warm the area of the machine and velcro is recommended especially in cold weather. Maximum adhesion occurs after 72 hours. It is recommended that the adhesive be allowed to set before the vehicle is used. Slight adjustments may be required to adjust cab enclosure to the desired position. Removing the Cab Enclosure 1. Unzip the doors from the roof enclosure. 2.