Rechargeable Power Supply Owner's Manual

110-volt AC Operation

CAUTION: Rechargeable Devices

Certain rechargeable devices are designed to be recharged by plugging them

directly into an AC receptacle. These devices may damage the inverter unit of the

Pocket Generator™

. When first using a rechargeable device, monitor its temperature

for the initial ten minutes of use to determine whether it emits excessive heat. If

excessive heat is detected, it is a good indication that the device should not be

used with this unit. This problem does not occur with the majority of battery-operated

equipment. Most of these devices use a separate charger or transformer that is

plugged into an AC receptacle. The

Pocket Generator™

is capable of running

most chargers and transformers.

1. Make sure that the ON/OFF switch on the inverter is in the OFF position.

2. Insert the 110-volt AC plug on the device to be operated into the AC outlet on

the power inverter.

3. Turn the power inverter’s ON/OFF switch to ON.

4. Switch on the device, and operate as usual. Run-time depends upon the amperage

draw of the device (see charts).

5. Green power/ON light next to switch will be lit.

12-volt DC Operation

WARNINGS

• When using the

Pocket Generator™ Rechargeable Power Supply

to run

12-volt devices, always check the polarity of the device to verify that it is negative

ground. The

Pocket Generator’s™

DC receptacle has an output limit of

10 amps; do not use it to power devices that require more than 10 amps.

Note:

The unit has an in-line 10-amp fuse that is designed to fail in the event the

unit is used with any device requiring more than 10 amps.

• Always turn the power inverter switch to OFF position while running any 12-volt

device, boosting vehicle battery system, using as Memory Saver, or recharging

the

Pocket Generator™

from either 110-volt AC or 12-volt DC power source.

Failure to do so will void manufacturer’s warranty.

1. Simply insert the device’s 12-volt plug into the DC receptacle on the side of the

Pocket Generator™

2. Switch on the device, and operate as usual. Run-time depends upon the

amperage draw of the device.

3. When necessary, recharge the

Pocket Generator™

, as directed in this manual.