Operating instructions

Parameterizing steps Vector Control Chassis Type Frequency Converter
476 869 4070 76 J AB-74 Siemens AG
9-22 Operating Instructions SIMOVERT MASTERDRIVES
87654321
Setpoint source
MASTERDRIVES VCOP1S / SIMOVIS and fixed setpoints at USS1 (P368=7)
- s7 -
P572.1
B (2112)
B2115 External fault
Src negative spd
B2114 Lower MOP B2110 PcD control B2112 Negative Spd
P571.1
B (2111)B2111 Positive Spd
B2109 Jog Bit1
P568.1
B (2108)B2108 Jog Bit0
P565.1
B (2107)B2107 Acknowledge
B2106 Setp Release B2105 No RGen Stop B2104 RGen Release B2103 Inv Release B2102 OFF3 (QStop) B2101 OFF2 (electr.) B2215
Src positive spd
Src Jog Bit0
Src1 Acknow.
B2200
Bit0
bis Bit15
K2002
P486.B
K
Src T setpoint
SCom1Word2
r709.2
P443.B
K (2002)
Main setpoint
K2001
SCom1Word1
r709.1
P707.1
K
K0032
ZUW1
r552
Status word 1
from sh.
[200]
P707.2
K
KK0148
n/f(act)
from sh.
[350.7], [351.7]
[352.7], [400.5]
Transmit actual values
Receive setpoints
Bit15
Baud rate
P701.1
PKW # P702.1
PcD #
P708.1
PKW:127
PcD: 2
Baud rate:
9.6 kB
PKW PKW PZD1 (Data word1) PZD2 (Data word 2) PKW PKW PZD1 (Data word1) PZD2 (Data word 2)
Control word 1
B2100 ON/OFF1
Bit0 Bit1 Bit7
Reserved for write operations of
parameter data
•
Reserved for read
operations of
parameter data
Sheet [100] Sheet [110]
P700.1 = Bus address P704.1 = Tlg failure time
B2113 Raise MOP
for T control:
• • • • • • • • • • • •
to sheet [180]
control word 1
r550
/10 RS485P /11 RS485N
•
PZD1 (Data word1)
Reserve
pos./neg. speed setp
Ramp-function gen. active
Energize main cont.
Undervoltage fault
Comp. setpoint reached
PcD control
Set/actual deviation
Alarm effective
Switch-on inhibit
OFF3 effective
OFF2 effective
Fault effective
Operation
Ready
Ready for ON
15 0
1
ZUW1
Setpoint via process data (only SIMOVIS):
Reset
I O
Bit8
Jog
Bit11 Bit12
P049 = OP operating display
OP1S keys
P554.1
B (2100)
Src ON/OFF1
to sh. [320.1]
-X101
Receive Transmit
to sh. [316.1]
N
M