Power Supply Owner's Manual

ManualsBrandsVector ManualsPower SupplyStart-It VEC020

THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY, OPERATION, MAINTENANCE AND STORAGE

OF THIS PRODUCT. BEFORE USE, READ AND UNDERSTAND ALL CAUTIONS, WARNINGS, INSTRUCTIONS AND

PRODUCT LABELS, PLUS YOUR VEHICLE’S BATTERY MANUFACTURER GUIDELINES. FAILURE TO DO SO COULD RESULT IN

POSSIBLE INJURY OR PROPERTY DAMAGE.

VECTOR MANUFACTURING, Ltd.

4140 S.W. 28th Way

Ft. Lauderdale, FL 33312

VEC020

4140 S.W. 28TH WAY, FT. LAUDERDALE, FL 33312

TEL: (954) 584-4446 • FAX: (954) 584-5556

www.vectormfg.com

START-IT

™

Compact Pro

™

JUMPSTART SYSTEM & POWER SUPPLY

PORTABLE, CORDLESS, RECHARGEABLE 12-VOLT DC POWER SUPPLY

OWNER’S MANUAL

COMPLETELY

PORTABLE,

SAFE AND

CONVENIENT

Summary of content (8 pages)

PAGE 1
VEC020 START-IT ™ ™ Compact Pro JUMPSTART SYSTEM & POWER SUPPLY PORTABLE, CORDLESS, RECHARGEABLE 12-VOLT DC POWER SUPPLY COMPLETELY PORTABLE, SAFE AND CONVENIENT OWNER’S MANUAL THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY, OPERATION, MAINTENANCE AND STORAGE OF THIS PRODUCT. BEFORE USE, READ AND UNDERSTAND ALL CAUTIONS, WARNINGS, INSTRUCTIONS AND PRODUCT LABELS, PLUS YOUR VEHICLE’S BATTERY MANUFACTURER GUIDELINES. FAILURE TO DO SO COULD RESULT IN POSSIBLE INJURY OR PROPERTY DAMAGE.
PAGE 2
ONE YEAR LIMITED WARRANTY REGISTRATION FORM All Vector Manufacturing, Ltd. products are warranted to the original purchaser only, for one year from the date of purchase, to be free of defects in materials and workmanship. In no event will Vector Manufacturing, Ltd. be responsible for any amount of damages beyond the retail purchase price of the product. All Vector Manufacturing, Ltd. products must be registered within ten days of purchase.
PAGE 3
8. SPECIFICATIONS Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .VEC020 Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12 VDC Boost Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .300 Instantaneous Cranking Amps Peak Ampere Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 4
CAUTIONS CAUTION STATEMENTS ADVISE AGAINST CERTAIN CONDITIONS AND PRACTICES THAT MAY RESULT IN DAMAGE TO VEHICLES, APPLIANCES, AND/OR THE START-IT Compact Pro™ JUMPSTART SYSTEM. 1. IMPORTANT: Although this unit is delivered in a partially-charged state, you must fully charge it with the supplied 110/120 volt AC charger for a full 24 hours before using it for the first time. You cannot overcharge the unit using the AC charger method. 2. Use only the supplied cords/adapters for recharging this unit.
PAGE 5
4.3 ESTIMATED BATTERY LIFE CONTENTS Table I shows the relationship of the frequency of use between recharging and the expected number of discharge/recharge cycles FEATURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 Table I - Estimated Battery Life AVERAGE NUMBER OF USES (JUMPSTART OR DISCHARGES) BETWEEN RECHARGES 1 ............... 5 ............... 10 . . . . . . . . . . . . . .
PAGE 6
4. CHARGING/RECHARGING FIGURE 1 2 10 11 4 12 1 1. 12 Volt DC Accessory Socket, with 20 amp overload protection 3 2. Safety ON/OFF Power Switch (No Key Required) 3. Charge Status Push Button 7 4. LED Charging/Battery Status Indicators 5. Heavy-Duty #6AWG Welding Quality Jumper Cables 5 8 6. Heavy Duty, 350 Amp Copper Clamps 9 7. Exclusive, Quick-Release, Clamp Holsters 8. 110/120 Volt UL approved AC/DC Charging Adapter Cord 9. 12 Volt DC/DC Charging Adapter Cord 6 10.
PAGE 7
POSITIVE GROUND SYSTEMS (UNCOMMON) NOTE: In the rare event that the vehicle to be started has a Positive Grounded System (positive battery terminal is connected to chassis): Replace step 4 and 5 above with steps, 4a and 5a and then proceed to steps 6 through 8 below. 4a. Connect negative (-) black clamp to vehicle battery‘s negative terminal. 5a. Connect positive (+) red clamp to vehicle chassis or a solid, non-moving, metal vehicle component or body part.
PAGE 8
Figure 1 Safety Switch Red LEDs Full Green LED Positive Battery Clamp Battery Status Pushbutton Negative Battery Clamp Worklight ON/OFF Switch 12 Volt Accessory Socket (DC Recharge) Worklight AC/DC Recharge Port WARNING: Automotive lead-acid batteries can generate hydrogen gas during normal operation. More gas is generated when the battery is charging.