Owner`s manual

CORDLESS OPERATION
1. Before cordless use, charge battery fully with 110 volt AC battery charger
adapter (included) (see instructions on page 4).
2. Move “Slide switch” on back of spotlight head to full left position to light
area light.
3. Move “Slide switch” to center position and pull trigger switch to light
one beam.
4. Move “Slide switch” to full right position and pull trigger switch to light
both beams.
CORDED OPERATION/DC RECHARGING FROM VEHICLE:
NOTE: During corded operation, the batteries will charge while the spotlight or
area light is being used.
* A full charge takes up to 2 to 3 hours using DC method with vehicle running.
1. Insert 12 volt DC power plug into DC power outlet on the unit.
2. Plug the other end into any vehicle’s accessory receptacle or other
compatible 12 volt DC power source that can supply at least 15 amps.
2
110V AC
CHARGER
ADAPTER
12V
CHARGER
POWER CORD
12V DC
POWER OUTLET
AND DC RECHARGING
PORT
110V AC
RECHARGING
PORT