User Manual

VEGAPULS 42 and 44 – 4 … 20 mA 83
Setup
Rx
VEGAMET VEGALOG
The most important adjustment steps
On the following pages you see a menu
schematic for the HART
®
handheld in con-
junction with VEGAPULS 42 and 44 sensors.
The most important adjustment steps are
marked in the menu schematic with the letters
A … E. For parameter adjustment, first press
the key " ENTER “. The adjustment is thereby
saved in the handheld, but not in the sensor
itself.
After pressing " SEND “, a warning is dis-
played which informs you that you are about
to modify the configuration, and that for
safety reasons, you should switch your sys-
tem over to manual operation.
4.2
(5.2)
After having pressed " ENTER “, press " SEND “
(here in the example for the min. adjustment).
Press " OK “ and the adjustment will now be
transferred to the sensor. After a short time
you are asked to switch your system over
from manual to automatic operation. Confirm
with " OK “.
You see the adjustment that was just carried
out.
Generic: SENSOR
1 PV LRV 5.850 m
2 PV URV 1.270 m
HELP SEND HOME
Generic: SENSOR
PV URV
5.850 m
1.270 m
HELP DEL ESC ENTER
Generic: SENSOR
WARN-Loop should be
removed from
automatic control
ABORT OK
Generic: SENSOR
NOTE- Loop may be re-
turned to automatic control
OK
Generic: SENSOR
1 PV LRV 5.850 m
2 PV URV 1.270 m
HELP HOME