User Manual

5 Remove the parabolic antenna (4) axially
6 Mount sensor flange to the adapter flange and clamp
it
7 Check if there is a O-ring seal on the adapter and if it
is not damaged. If necessary, replace it: Viton, article
no. 2.28248, Kalrez 6375 article no. 2.27351.
8 Remount the parabolic antenna (4)
9 Tighten compression nut (3) with SW 41, torque max.
50 Nm.
10 Tighten locknut (2) with SW 36, torque max. 40 Nm.
1
2
3
4
Fig. 5 : Dismounting, parabolic antenna
1 Compression nut
2 Locknut
3 Connection piece
4 Parabolic antenna
4.4 Mounting information
The illustrations on the mounting instructions show a
VEGAPULS 68 with horn antenna. The mounting
instructions also apply to VEGAPULS 68 with parabolic
antenna.
Horn and parabolic anten-
na
16 VEGAPULS 68 - 4 ... 20 mA/HART
Mounting
29261-EN-050202