User Manual

5 Save the settings with [OK] and move to max.
adjustment with [–>].
Proceed as follows:
Max. adjustment
100.00 %
=
1.000 m(d)
2.000 m(d)
1 Prepare the percentage value for editing with [OK]
and set the cursor to the requested position with [–>].
Set the requested percentage value with [+] and
save with [OK]. The cursor jumps now to the
distance value.
2 Enter the appropriate distance value in m (corre-
sponding to the percentage value) for the full vessel.
Make sure that the max. level must be beneath the
dead zone.
3 Save the settings with [OK] and move to the medium
selection with [–>].
Each product has different reflective properties. In
solids, these are dust generation, material cones and
additional echoes caused by the vessel wall. Due to the
medium selection, the sensor is adapted in an optimum
way to the product and the accuracy, particularly for
products with bad reflective properties, is increased
considerably.
Medium
Solid
For solids you choose also Powder/Dust, Granular/
Pellets or Ballast/Pebbels.
In liquids, fluctuating surfaces and foam generation are
further interfering factors. To adapt the sensor to the
different conditions, a general selection is made in this
menu item, i.e. Solid or Liquid.
Carrying out max. adjust-
ment
Medium selection
36 VEGAPULS 68 - 4 ... 20 mA/HART
Setup with the indicating and adjustment module PLICSCOM
29261-EN-050202