User's Manual

Press the respective key until the indication is within the LED indication
strip. This means one or two LEDs on the LED indication strip light up.
1
CBA
2
3
Fig. 29: Indication board
1 Indication (LED indication board)
2 More sensitive - Key to the left
3 Less sensitive - Key to the right
A Medium: Plastics (PP, PVC …), solvents
B Medium: Building material (sand, stones …)
C Medium: Conductive substances (coal, ore, salt …)
Set the indication approximately to the middle of the LED indicating
board until the yellow relay control lamp changes condition.
Depending on the vessel size, process and/or medium, you have to
adjust the sensitivity of VEGAMIP 61 more or less sens itive. In
products with low signal damping, in small vessels or pipelines or with
buildup, it can be necessary to test the switching function.
By means of the LED indicating board, you can see the actual
receiving level during adjustment.
When the indication moves to the right, the instrument will be more
insensitive, to the left more sensitive.
In applications with products having a good signal damping (for
example stones, ore, sand, cement) and where buildup and
contamination is expected, you should adjust the instrument more
insensitive. In this case, the VEGAMIP 61 switches only with a
relatively high signal damping by the medium. Probable buildup does
not influence the measurement.
Receiving level
Medium delivers good
signal damping
VEGAMIP R61 • - Relay 25
6 Setup
35786-EN-100531