User Manual

5 Insert the cable into the sensor through the cable entry

Fig. 18: Connection steps 5 and 6

6 Insert the wire ends into the terminals according to the wiring plan

Information:

Solid cores as well as ﬂexible cores with cable end sleeves are

inserted directly into the terminal openings. In case of ﬂexible cores

without end sleeves, press the terminal head with a small screwdriver;

the terminal opening is freed. When the screwdriver is released, the

terminal closes again.

7 Check the hold of the wires in the terminals by lightly pulling on

them

8 Connect the screen to the internal ground terminal, connect the

outer ground terminal to potential equalisation

9 Tighten the compression nut of the cable entry. The seal ring must

completely encircle the cable

10 Screw the housing cover on

The electrical connection is ﬁnished.

Information:

The terminal block is pluggable and can be removed from the

electronics. For this purpose, lift the terminal block with a small

screwdriver and pull it out. When inserting the terminal block again,

you should hear it snap in.

VEGAPULS 62 • 4 … 20 mA/HART two-wire 27

5 Connecting to power supply

36503-EN-100607