User Manual

Menu Menu item Default value
Scaling 0.00 lin %, 0 l
100.00 lin %, 100 l
Lighting Switched off
Further settings Distance unit m
Temperature unit °C
Probe length Length of the standpipe Ex factory
Linearisation cur-
ve
linear
HART mode Standard
Address 0
6.4 Saving the parameter adjustment data
It is recommended noting the adjusted data, e.g. in this operating
instructions manual and archive them afterwards. They are hence
available for multiple use or service purposes.
If the instrument is equipped with an indicating and adjustment
module, the data in the sensor can be saved in the indicating and
adjustment module. The procedure is described in the operating
instructions manual "Indicating and adjustment module" in the menu
item "Copy sensor data". The data remain there permanently even if
the sensor power supply fails.
The following data or settings for adjustment of the indicating and
adjustment module are saved:
l All data of the menu "Setup" and "Display"
l In the menu "Additional settings" the items "Distance unit,
temperature unit and linearization"
l The values of the user programmable linearization curve
The function can be also used to transfer settings from one instrument
to another instrument of the same type. If it is necessary to exchange a
sensor, then the indicating and adjustment module is inserted into the
replacement instrument and the data are also written into the sensor
via the menu item "Copy sensor data".
VEGAPULS 62 • 4 … 20 mA/HART two-wire 41
6 Set up with the indicating and adjustment module
36503-EN-100607