User's Manual
Table Of Contents
- 1 About this document
- 2 For your safety
- 3 Product description
- 4 Mounting
- 5 Connecting to power supply
- 5.1 Preparing the connection
- 5.2 Connecting
- 5.3 Wiring plan, single chamber housing
- 5.4 Wiring plan, double chamber housing
- 5.5 Double chamber housing Ex d
- 5.6 Wiring plan, double chamber housing Ex d ia
- 5.7 Double chamber housing with DISADAPT
- 5.8 Wiring plan - version IP 66/IP 68, 1 bar
- 5.9 Switch-on phase
- 6 Set up with the display and adjustment module
- 7 Setup with PACTware
- 8 Set up with other systems
- 9 Diagnosis, asset management and service
- 10 Dismount
- 11 Supplement
96
INDEX
VEGAPULS 69 • 4 … 20 mA/HART - two-wire
47247-EN-170315
INDEX
A
Adjustment 43, 48, 49
C
Change the language 50
Check output signal 68
Connection
– Cable 31
Copy sensor settings 54
Current output
– Adjust 55
– Min./Max. 50
– Mode 49
Curve indication
– Echo curve 51
D
Damping 49
Date/Time 53
Default values 53
Deviation 69
Display lighting 51
E
Echo curve
– Setup 52
EDD (Enhanced Device Description) 63
Electrical connection 32
Electronics and terminal compartment 34
Error codes 67
Event memory 64
F
False signal suppression 55
Faultrectication68
Functional principle 12
G
Grounding 32
H
HART 60
– Address 57
L
Linearisation 57
M
Main menu 44
Measured value memory 64
Measurement loop name 45
Mounting
– Flange 18
– Strap 17
Mounting socket 22
N
NAMUR NE 107 65, 66, 67
P
Peak value indicator 51
Polarisation 20
R
Repair 72
Reset 53
S
Sensor status 51
Service hotline 71
Set display parameters 51
Simulation 52
Special parameters 57
T
Type label 11
V
Vessel installations 26
Vessel insulation 27