User's Manual

6 Setup with the indicating and
adjustment module PLICSCOM
6.1 Short description
The indicating and adjustment module PLICSCOM is used for
measured value display, adjustment and diagnosis. It can be
mounted in the following housing versions and instruments:
l All sensors of the plics
®
instrument family, in the single as
well as in the double chamber housing (optionally in the
electronics or connection compartment)
l External indicating and adjustment unit VEGADIS 61
From a hardware revision …- 01 or higher of PLICSCOM as
well as the corresponding sensor, an integrated backlight can
be switched via the adjustment menu. The hardware revision is
stated on the type label of the PLICSCOM or the sensor
electronics.
Information:
This function is for instruments with StEx, WHG or ship
approval as well as country-specific approvals such as those
acc. to FM or CSA, available at a later date.
Note:
You will find detailed information on the adjustment in the
operating instructions manual of the indicating and adjustment
module PLICSCOM.
6.2 Installing the indicating and adjustment
module PLICSCOM
PLICSCOM can be inserted or removed at any time. Itisnot
necessary to interrupt the power supply.
Proceed as follows:
1 Unscrew the housing cover
2 Place PLICSCOM in the desired position on the electronics
(you can choose any one of four different positions - each
displaced by 90°)
3 Press PLICSCOM lightly onto the electronics and turn it to
the right until it snaps in.
Function/Configuration
Insert/remove PLICSCOM
Setup with the indicating and adjustment module PLICSCOM
34 VEGAPULS 62 - 4 ... 20 mA/HART
28435-EN-060317