User's Manual

In Ex applications, only an instrument and an electronics
module with appropriate Ex approval may be used.
If there is no electronics module available on site, one can be
ordered from the VEGA agency serving you.
The order data of the sensor must be downloaded into the new
electronics module. This can be done:
l at the factory by VEGA personnel
l or on site by the user
In both cases, the sensor serial number is necessary. The
serial numbers are stated on the type label of the instrument or
on the delivery note.
Information:
When loading on site, the order data must be downloaded from
the Internet (see Operating Instructions manual of the
oscillator).
The oscillators are adapted to the respective sensor and differ
in their signal output or in their power supply. You can find a
suitable oscillator in the following overview.
Oscillator PS-E.60KH. is suitable for K-band VEGAPULS 61,
62, 63 - 4 … 20mA/HART:
l PS-E.60KHX (X = without approvals)
l PS-E.60KHA (A = approvals CA, DA, EA acc. to VEGA
product list)
l PS-E.60KHD (D = approvals XM, CM, CK, CI, DM, DK, DI,
EX, GX, UX, UF acc. to VEGA product list)
l PS-E.60KHE (E = approvals CX, DX acc. to VEGA product
list)
Oscillator PS-E.60SH. is suitable for VEGAPULS 61, 62, 63 -
4 … 20 mA/HART:
l PS-E.60SHX (X = without approvals)
l PS-E.60SHD (D = approvals CK, GX acc. to VEGA product
list)
l PS-E.60SHE (E = approvals CX, DX acc. to VEGA product
list)
8.4 Instrument repair
If a repair is necessary, please proceed as follows:
You can download a return form (23 KB) from our homepage
Sensor serial number
Assignment
4 … 20 mA/HART
4 … 20 mA/HART with in-
creased sensitivity
Maintenance and fault rectification
52 VEGAPULS 62 - 4 ... 20 mA/HART
28435-EN-060317