User guide

46
6Setupwiththedisplayandadjustmentmodule
MINITRAC 31 • Foundation Fieldbus
41782-EN-131119
Info
Inthismenuyouwillndthefollowingmenuitems:
•
Instrumentname-showsinstrumentnameandserialnumber
•
Instrumentversion-showshardwareandsoftwareversionofthe
instrument
•
Dateofmanufacture-showscalibrationdateandthedateofthe
last change
•
DeviceID-showsthedeviceIDandthesensorTAG(PD_TAG)
•
Instrumentfeatures-showsfurtherinstrumentfeatures
These parameters are described in the operating instructions manual
"Display and adjustment module".
6.5 Parameter adjustment/Level detection
The instrument is adapted to the application conditions via the pa-
rameteradjustment.Theparameteradjustmentiscarriedoutwithan
adjustment menu.
Information:
Inthisoperatinginstructionsmanual,theinstrument-specicparam-
eters are described. Further general parameters are described in the
operating instructions manual "Display and adjustment module".
Caution:
Duringtherstsetuporafteraninstrumentresettheinstrumentstarts
withpresetstandardvalues.Thesevaluearenotsuitableforyourap-
plication and must be replaced by real values.
Carryoutasetupinthesequencedescribedinthefollowing.
Themainmenuisdividedintovesectionswiththefollowingfunc-
tions:
Setup: Settings, e.g. for measurement loop name, isotope, applica-
tion, background radiation, adjustment, signal output
Display: Settings, for example language, measured value display
Diagnosis: Information, for example, of device status, peak value,
simulation
Additional adjustments: Instrument unit, reset, date/time, copying
function
Info:Instrumentname,hardwareandsoftwareversion,dateofmanu-
facture, instrument features
Check if the correct language is already set for the display. If not, you
can change the language in the menu item "Display/Language".
Info
Instrument start
Main menu
Procedure