User guide

52
6Setupwiththedisplayandadjustmentmodule
MINITRAC 31 • Foundation Fieldbus
41782-EN-131119
In this menu item you can simulate measured values via the current
output.Thisallowsthesignalpathtobetested,e.g.throughdown-
stream indicating instruments or the input card of the control system.
Note:
Tocarryoutasimulationwiththedisplayandadjustmentmodule,
youhavetoswitchonthesimulationswitchontheelectronicsmodule
(switchposition1).
Youcanndtherotaryswitchontheelectronicsmoduleintheelec-
tronics and connection department (large cover).
Youcansimulatedierentvalues:
Pulse rate of the sensor
Switchingfunctionoftherelay
Information:
10minutesafterthekeywaspressedforthelasttime,thesimulation
isinterruptedautomatically.Youcanalsointerruptthesimulationwith
theswitchontheelectronicsmodule.
The sensor calculates a suitable integration time automatically.
Additional adjustments
In this menu item, the PIN is permanently activated/deactivated. Thus
youprotectthesensordataagainstunauthorizedaccessandunin-
tended changes. The default setting of the PIN is 0000.
This parameter is described in the operating instructions manual
"Display and adjustment module".
Diagnosis - Simulation
Diagnosis - Calculated
damping
Additional settings - PIN