User guide

53
6Setupwiththedisplayandadjustmentmodule
MINITRAC 31 • Foundation Fieldbus
41782-EN-131119
In this menu item you can set the actual date and time.
This parameter is described in the operating instructions manual
"Display and adjustment module".
Whenaresetiscarriedout,allsettings(withonlyafewexceptions)
are reset. The exceptions are: PIN, language, SIL and HART mode.
Thefollowingresetfunctionsareavailable:
Basic settings: Resetting of the parameter adjustments to default
valuesatthetimeofshipment.Order-specicsettingsaredeleted.
Default settings: Resetting of the parameter adjustment like under
"Basic settings". In addition, special parameters are reset to default
values.Order-specicsettingsaredeleted.
Peak values of measured value: Resetting of the parameter adjust-
ments in the menu item "Setup" to the default values of the respective
instrument.Order-specicsettingsremainbutarenottakenoverinto
the current parameters.
Peak values of temperature: Resetting of the measured min. and
max. temperatures to the actual measured value.
Thefollowingtableshowsthedefaultvaluesoftheinstrument.The
values apply for the application "Level". First of all you have to select
the application.
Depending on the instrument version, not all menu items may be
availableortheymaybedierentlyassigned:
Menu Menu item Default value
Setup Measurement loop name Sensor
Isotope Cs-137
Application Limit level
Adjustment mode Single point adjustment
Adjustment - uncovered 90000 ct/s
Adjustment - covered 9000 ct/s
onlywithtwo-pointadjust-
ment
Delta I 90 %
Background radiation 0 ct/s
Temperature unit ° C
Adjustment mode 1-point
Adjustment uncovered 900000 ct/s
Delta I 90 %
Mode relay Overllprotection
Block adjustment Released
Additional adjustments -
Date Time
Additional adjustments
- Reset