Manual

4 Moun
ting
4.1 General instructions
The new electronics module must be loaded with the order and factory
data of the sensor. These are the options:
l At the factory by VEGA
l Or on site by the user
Informa
tion:
When loading on site, first of all the order data must be downloaded
from the Internet (see "Setup").
In both cases, the sensor serial number is necessary. The serial
numbers are stated on the type label of the instrument, inside the
housing or on the delivery note.
Caution:
Th
e order data and company data contain important prese ttings for the
sensor. A reliable operation and a correction of the measurement is
not possible without these data.
War
ning:
Switch off voltage supply before starting the mounting procedure. The
replacement electronics must only be mounted in idle condition. Non-
observance will damage the electronics!
Th
e safety-relevant data for expl osion protection of the electronics
module supplied later can deviate from the data of the previously
installed electronics module. If the electronics modue supplied later, is
installed in a certified, explosion-protected sensor, it is absolutely
necessary to observe the instrument "Safety instructions" attached to
the supplied electronics module! The attached label must be applied
on the sensor housing.
4.2 Mounting preparations
The electronics modules are adapted to the respective sensor. First of
all check by means of the following lists if you are using a suitable
electronics module.
VEGAPULS 61, 62, 63
l PS60EE.60KH for version 4 … 20 mA/HART
l PS60EE.60KD for version 4 … 20 mA/HART with increased
sensitivity
l PS60EE.60KV for version 4 … 20 mA/HART four-wire
Sensor serial number
Assignment
Ele
ctronics module • VEGAPULS series 60 7
4 M
ounting
36801-EN-101008