Owner`s manual

ManualsBrandsVehicle Systems ManualsDomestic AppliancesH2E-200-01E

Hydro-Hot Hydronic Heating System Shop Manual 07/03

4.8 Circulation Pump #2 Indicator Light

This indicator light will illuminate GREEN whenever Circulation Pump #2 is

operating, reference Figures 1 and 5. Please note that this light will only be

active if the Hydro-Hot is at normal operating temperature (i.e. between

160

��

�F and 190

��

�F) and if either Heating Zones #2, #3, or #4 are calling for

heat, reference Figure 3. If this light illuminates RED, it indicates an

electrical overload condition (i.e. short) has occurred in this particular

component's circuitry.

4.9 Stir Pump Indicator Light

This

indicator light will illuminate GREEN whenever there is a continuous

demand

for domestic hot water (i.e. during a shower), reference Figures 1

and 5. Please note that this light will be active only when the Diesel switch

is turned ON, reference Figure 4.

4.10 Low Battery Voltage Fault Indicator Light

This indicator light will illuminate RED whenever the VDC voltage level is

too low for the Hydro-Hot to operate properly, reference Figure 5. This fault

must be manually reset after the voltage level has been restored to the VDC

battery system, reference Section 4.3 for reset instructions.

4.11 Low Temp Cutoff Status Indicator Light

This

indicator light will illuminate GREEN whenever the Hydro-Hot is able to

provide heat for both the Interior and Fresh Water Tank Heating Zones,

reference Figure 5. Whenever this indicator light is OFF, it indicates that

domestic hot water is being used on a continuous basis (i.e. during a

shower).

NOTE:

The Hydro-Hot will not provide both interior zone heating and a

continuous supply of domestic hot water simultaneously; Domestic Hot

Water will take priority over Interior Heating. This is referred to as the

"Domestic Water Priority System".

4.12 Diesel-Burner Status Indicator Light

This

indicator light will illuminate GREEN whenever the Hydro-Hot's Diesel-

Burner is operating and supplying heat to the Hydro-Hot's Boiler Tank,

reference Figures 1 and 5. Please note that this light will only be active if

the Diesel switch is turned ON, reference Figure 4.

4.13 Overload Fault Indicator Light

This

indicator light will illuminate RED (reference Figure 5) whenever one of

the following conditions have occurred:

1. The Hydro-Hot is off due to an electrical overload (i.e. short) in the

main VDC power supply circuitry.

2. The Hydro-Hot is off due to a combination of high electrical VDC

power loads and a high surface temperature of the Electronic

Controller.

The Hydro-Hot will automatically restart once the electrical overload (i.e.

short) and/or high heat condition is corrected.

Page 7

Section 4: General Heater Information

Electronic

Controlle

continue