Owner`s manual

Hydro-Hot Hydronic Heating System Shop Manual 07/03
R
Page 2
Section 1: General Heater Information
1.2 Identification Plate
I.D. Plate
Figure 2
Model Number
Box
Serial Number
Box
Manufactured
Date Box
Model Number
Serial Number
Manufactured Date
Diesel-Burner / DC Power
Fuel Type / Firing Rate
Electric Heating
Element / AC Power
Testing
Engineers
International
Complies with the requirements
of U
L 307A
Made in U.S.A.
For Installation Only in Compartment Completely
Closed Off from Living Quarters and
Accessible
Only from the Outdoors
Exhaust system MUST NOT terminate beneath
the vehicle or under an openable window or vent.
Combustion
Air MUST BE supplied
from outside the vehicle.
CAUTION: This appliance operates on
both
AC and DC Electrical Power.
The
AC Powered Electrical Heating Element can be
wired using flexible nonmetallic cable (ROMEX).
USE COPPER CONDUC
TORS ONLY
CAUTION: The Mixing /
Anti-Scald Valve
must be installed with this product.
Use 25
Amp fuse for over current protection
for DC Power suppl
y.
Use 20
Amp Circuit Breaker for over current
protection for
AC Power supply.
Mount Heater near a Bay / Storage Door so
Acess Cover can be easily removed.
Minimum Heater clearances
Front - Open
Acess
Back - 8 inches
Top - 9 inches
Sides - 0 inches
Install in strict compliance with local codes, NF
PA
501c and manufacturer’s instructions.
HHE-500-07M
HM02-224
06-02
12 VDC / 170 Watts
120 VAC, 60 Hz / 1.65 kW
DIESEL / 50,000 BTU
Reference Figure 1 for
I.D. Plate locations.