Instructions / Assembly

Step 12: Right roller support assembly:

Insert the shaft of roller into roll tube plug, meanwhile insert the torsion bar into the right roller supports with hitting.

Then tighten the right hexagon bolt by 5mm Hexagon wrench. As shown in the figure below:

Step 13: Assemble to make a whole awning

Make the valance through groove of front bar, pay attention to the direction and make sure the left and right sides on

average, then hitting the cover of fro

nt bar into end of front bar. As shown in the figure below:

If the part of front bar is a lile deformed, please adjust it with tools by yourself.