Instructions / Assembly

8
Step 7: Link the self-locking nut
Link the self-locking nut into screw which at the bottom of the screw in front bar feet by a wrench, stop when the thread
leakage 1 ~ 2 laps. As shown in the figure below:
ATTENTION: BEFORE BLOCKING THE NUT, ENSURE THAT THE ARMS ARE PROPERLY ALIGNED.
Step8: Left roller support with gear box assembly:
Hammer the left roller support with gear box into the left end of torsion bar by wood hammer, then tighten the left hexagon
bolt by 5
mm Hexagon wrench. As shown in the figure below:
1
14
12