Installation Guide

B-1
B-2
B-1
B-2
Connect parts "B-1" and "B-2"
Connect steel square tubes with screws "S
"
Put the square tube "B-1" into the part
"D-1" and tighten the screws on part "D-1"
S
B-1 X1
B-2
X1
D-1 X1
S X2
S
D-1
B-1
Attention:
Do not remove the bindings holding the two extension arms until fully assembled. These are
spring-loaded and can cause serious injury if allowed to spring free.