STOP’ MISSING A PART? ® CALL US BEFORE GOING BACK TO THE STORE The store where you made your purchase Does not stock parts for this item. If you have assembly questions or you are missing or have damaged parts,please call 1-858-324-1911 (Mon Fri, 10:00 am to 7:00 pm EST) you can also e-mail or visit www.veikous.com Please prefer email contact. Due to busy lines, there may be a wait for calls to be answered.
60" NATIVITY SCENE | SE A Holy mother 1 B Arm 1 c Upper body of holy father 1 D Lower body of holy father 1 E Arm 1 F Staff 1 G Holy son 1 H Stander 1
I Star J Upper arch Lower arch Stander : M Plastic Ties N Ground Stake ° Latch Ct MAKE SURE TO FOLLOW THE STEPS BELOW FOR A SUCCESSFUL & EASY ASSEMBLY TIP: To ensure the final unit Is secures and sturdy It Is highly recommended to ‘secure each component with the zip ties provided after connecting sate component together In the steps.
TO ASSEMBLE 1. Remove all components from the box and lay fiat on the floor. NOTE: Some parts are connected by a string of lights and should NOT be separated. Any separation or disconnection of the light set may cause the unit to malfunction or not light compliantly. 2. instar the prongs on the Upper arch (J) Into the corresponding rings of the Lower arch(K) (see Fig 1) 3. Insert the prongs on the Star (I) into he corresponding rings of the Upper arch{J). {see Fig.1} Fig.
4. Insert the prongs on the Stander (L) into the corresponding rings of the Lower arch(K). (see Fig.2) 5. Secure the end of the stander pole by fully inserting the Latch(Q) into the hole. (see Fig.2) Fig.
Insert the prongs on the Upper body of holy father(C) into the corresponding rings of the Lower body of holy father(D). (ses Fig.3) Insert the prong on the Arm (E} into the corresponding rings of the Upper body of holy father(C) {sea Fig.3) Insert the prongs on the Staff (F) Into the corresponding rings of the Upper body of holy Fig 3) {a) Insert the prong on the bottom of the Lower body of holy father(D) Into the corresponding metal cylinder of the stander(L). (see Fig.
10. Insert the prong on the Am (B) Into the compounding rings of the holy motherboard. (see Fig.4) 11. (a) Insert the prang on the bottom of the holy mother(A) into the corresponding metal cylinder of the standstill. (see Fig.4) {b) Put the metal cylinder on the bottom of the holy mother{A) onto the corresponding post of the standstill. (see Fig 4) {c) Hook the and of the rod of the stander(L} into the corresponding ring of the holy mother{A).
12. Connect the Stander (H) and the Holy son (G) by inserting the metal hooks into the corresponding metal ring (STEP 1), insert the metal posts into the corresponding metal cylinders. (STEP) {see Fig.5) 2 Fig.5 13. VERY IMPORTANT: Secure the installing points with plastic ties(M) and secures the base to the soft ground by fully inserting Ground stakes(N} into the ground.
14. Connect the plug to the extension cord and plug the light set into a standard 120-volt AC electrical outlet.
