Operating Instructions and Installation Instructions

4-2. Basic operation methods
Power Consumption:12W
POWER CONNECTIONS
There are four wires (Red ,Black,Brawn and White) to the power
switch module.
The wires have the following functions:
RED WIRE (15 Amp Fused)
Connect this wire to a common +12 V or +24 V source.
BLACK WIRE
Connect this wire to a common negative chassis point that is clean
and free from rust.
BROWN WIRE
This wire must be connected to the positive side of the reversing
bulbs or a switched positive output from the reverse gear switch
wire.When the driver selects reverse gear the reversing lights
receive a switched +12/24 V to the positive side of the bulbs,which
supplies voltage to the brown wire and activates the monitor for
reverse camera viewing.
WHITE WIKE
A pre-fitted power connector please leoeve it your do
not use it
Receiving Frequency:ISM 2,400~2,483MHZ
3.BOX
4. POWER CONTROLED BY SWITCHING BOX4. POWER CONTROLED BY SWITCHING BOX
System
Input AV
Color System AUTO
Language Chinese
Select
Adjust
Down Select VOL + / VOL - : Adjust
1. TFT LCD MONITOR1. TFT LCD MONITOR
(2) System
Input, Color System and Language displays on the screen as
illustrated below:
Press Down select the item Input:
Then press VOL- or VOL + to shift the picture from AV1 to Av2.
Press Down to select the item Color System
Then press VOL - or VOL+ to revolve the screen in order of AUTO,
PAL,N3.58 and N4.43. Please choose carefully the correct system,
otherwise,it may cause achromatic or inferior color. It is
recommended to select on AUTO position.
411
System
Input AV
Color System AUTO
Language Chinese
Select
Adjust
Down Select VOL + / VOL - : Adjust
4-1. Appearance
Ground (black)
DC 12~32V Power (red)
Backward IN (brown)
NC (white)
1
2
3
4
1
2
3
4
CAM1/CAM2
ON/OFF
B/DC/A/V OUT
Video 1 OUT
Audio 1 OUT
Backward OUT
1
2
3
Ground
DC 12V OUT
Video 2 OUT
4
5
6
2
1
3
4
5
6
B/DC/A/V OUT
POWER IN
AUDIO IN VIDEO IN
A V 1
3
9mm
120mm
ANT
DC 12/32V
PL