Installation manual

QuickClip ™
124
Internal
This section determines the presets for each internal channel supported by your system. If
you need to change any of these assignations, it will be either because you know what
you are doing, or you have been instructed to do so by QuickClip Technical Support. Do
not experiment with the default settings, as this may result in a loss of communications
within the board set, undermining the functionality of the unit.
Channel In a single channel box, the internal
channel will be Int0. For a two channel system, the first channel would stay the same and
the second channel would be Int1. Additional internal channels would be Int2 and Int3
etc. (depending on the system configuration).