Users Manual

SETUP12

5 INSPECT THE ALIGNMENT

If the indicator tab of the Alignment Tool is not aligned with the

groove on the Alignment Ring (as shown below), move to step 6.

If the indicator tab of the Alignment Tool is aligned with the

groove on the Alignment Ring (as shown below) skip to step 8.

6 ALIGN USING THE ADJUSTMENT DRIVER

Locate the Driver Slot and place your Adjustment Driver in

begin to adjust your height as needed. Turning to the right

moves the adjustment ring closer to you while turning to left

moves the ring to the back. Adjust until the indicator tab is

aligned with the groove on the Alignment Ring. End

Alignment

Mode

by pressing the



Alignment Button.

Alignment Tool into the slot and let it fall into place. Release

the Clamp Lever.

3 INITIATE ALIGNMENT MODE

Press the



Alignment Button to send the Carriage to its

alignment position. When the Carriage is in place, a tone will

sound and the case will illuminate white.

4 LOCATE THE TAB AND GROOVE

Look through the eyepiece of the Optical Alignment Tool and

locate the indicator tab (A) of the

Optical Alignment Tool and

the groove (B) on the

Alignment Ring.

Ensure you are looking straight through the eyepiece directly

above the indicator tab and groove. If you see the indicator tab

side wall (C) when looking through the eyepiece, you are not

directly above the indicator tab and groove. Adjust your line of

sight until you can no longer see the indicator tab side wall.

SHOT OF DRIVER IN THE SLOT

ADJUSTING ALIGNMENT