Users Manual

OPERATION20
2 CONTINUE THE SHARPENING PROCESS
Refer to “Loading a Skate” in the Operation section of the
manual. When adjusting the Grinding Ring Height, refer the
graphic in step 3.
3 ADJUST THE GRINDING RING HEIGHT
Refer to “Adjusting the Grinding Ring Height” in the Operation
section of the manual using the figure below as your guide
where the desired contact point is A, contact point B is too high
and contact point C is too low.
5 CONTINUE THE SHARPENING PROCESS
Refer to “Sharpening Skates” in the Operation section
of the manual.
6 REMOVE THE GOALIE RISERS
Pull up on each end of the Goalie Risers to remove from the
Skate Clamp.
GOALIE SKATES
To watch the How-To video, visit sparxhockey.com/loadgoalie.
Goalie risers are necessary if your skate has a cowling. Goalie skates
without a cowling you may sharpen normally without risers.
If your skate does not have a cowling, follow the steps below.
1 INSTALL THE GOALIE RISERS
Align the Anchor Pins (A) of the Goalie Risers to the Anchor
Slots
of the Skate Clamp. Once aligned, press down firmly until
you feel the Goalie Risers snap into place.
SHOT OF NEW SLOT COVERS