Users Manual

OPERATION 21
2 ADJUST THE GRINDING RING HEIGHT
Set the grinding ring height setting to Figure (1). Look for the
contact point at which the grinding ring starts to roll on the skate
using the move button. Use the figure below as your guide where
the desired contact point is A, contact point B is too high and
contact point C is too low. If the contact point is leaving some of
the skate blade untouched you may need to adjust the adapter
slightly higher.
3 INSERT SKATE INTO SKATE CLAMP
We recommend having the tail of the blade pointing right. Ensure
that the adapters are sitting flush with the top surface of the
sharpener (A).
4 CONTINUE THE SHARPENING PROCESS
Refer to “Sharpening Skates” in the Operation section
of the manual.
A
B
FIGURE SKATES
To watch the How-To video, visit sparxhockey.com/figure.
* Figure Skate Adapters.are sold separately.
Before loading a figure skate,
Figure Skate Adapters must be
installed onto each end of the skate steel as shown below.
1 PLACE ADAPTER OVER TAIL AND TOE PICK
Using the included wrench tighten the set screw until finger tight
do not over tighten, the adapter should still be able to pivot.
Be sure to keep the drag pick covered. After both adapters are
installed perform a visual to check to ensure that both adapters
are on a level horizontal plane.