Use and Care Manual

14
PROBLEM POSSIBLE CAUSE SOLUTION
The light does not
work.
Not plugged in. Plug the cooler in.
The circuit breaker tripped
or a blown fuse.
Check the breaker and/or fuses.
The light button is “OFF”.
Press to turn the light ON.
Vibrations.
The cooler is not le vel ed. Check to assure that the cooler is level.
The bottles are vibrating.
Make sure the bottles don
’
t t ouch each
others.
There is an object under the
cooler.
Remove the object under the cooler.
The cooler seems to
make too muc
h
noise.
The cooler is not le vel . Level the cooler.
Normal noi se from the flow
of the refrigerant
The rattling noise may come f r om the flow
of the refrigerant, whi ch i s normal. As each
cycle ends, you may he a r gurgling sounds
caused by the flow of refrigerant in your
cooler. Con traction and expansion of the
inside walls may cause popping and
crackling noises.
The door will not
close properly.
The cooler is not le vel . Level the cooler.
The door was reversed and
not properly instal
led.
Re-install the door properly.
The gasket is dirty. Clean the door gasket.
The shelves are out o f
position.
Place the shelves properly.
Moisture build up on
interior or
exterior of the
Beverage cooler.
This is normal during high
humidity periods.
Lower the room humidity.
This is normal in high
temperature enviro nment.
Move the cooler to a cooler place, and avoid
heat and sunlight.
Prolonged or frequent door
openings.
Open th e door less often.
The door does not sea l
compl
etely.
Check door gaskets for proper seal.
Error Code:
E1-E2-E3-E4-E7-E8
A sensor has failed. Contact the customer service