Use and Care Manual

7
Illustration #1 Illustration #2
To Install Your Beverage cooler
This Beverage cooler is designed for free standing or built-in (fully recessed) installation.
Place your Beverage cooler on a solid and level floor that is strong eno ugh to support it when
it is fully loaded. This will ensure a vibration-free and noise-free operation. Adjust the leveling
legs in and out to stabi lize the cooler horizontally. If the legs are not properly adjusted, the
cooler may be unstable and result in exces s noise or vibration.
Locate the Beverage cooler a
way from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extremely cold ambient temperatures may also caus e the cooler not
to perform properly.
It is not advisable to install this cooler in moi st areas or directly adjacent to a kitchen sink, as
moisture could cause premature corrosion to the comp onents of your new cooler.
It is recommended you i nstal
l the Beverage cooler in a place with tempe ratures above 60°F
(15°C) and below 90°F (32°C), and humidity is unde r 60%. If the ambient temperature is
above or below recommended temperatures, the performance of the cooler may be affected.
Placing your cooler in extremely cold or hot conditions may cause interior temperatures to
1 Gasket
2 Screw
3 Screw Driver
4 Handle
-
-
-
-
-