Owner manual

4
b) Right-click on “Local Area Connection”, and select “Properties”.
c) In the “General” tab, select “Internet Protocol Version 4 (TCP/IPv4)”, and select “Properties”.
d) In the “General” tab, select “Use the following IP address”, and set the IP address as described above.
e) Click “OK” to close the “Internet Protocol Version 4 (TCP/IPv4) Properties” dialog box. Then, click
“Close” to close the “Local Area Connection Properties” dialog box.
Step3: Double-click “ ” on your PC desktop to open Video Viewer. By defaults, the “Address
Book” panel will be displayed on the right side of the control panel.
Step4: Click “ ”  “ ” to key in the default IP address, user name, password, and port
number of the device you intend to connect.
The default values are as follows:
Item Default Value
IP address 192.168.1.10
User name admin
Password admin
Port 80
OR
Click “ ”  “ ” to search the available IP address(es) of other DVR(s) under
the same domain as your PC’s IP address. The found address(es) will be listed, and can
be added into the address book by clicking “ ”.
Step5: Double-click the IP address you just added into the address book to log in.