RECORDER USERMANUAL PCSU1000
I Waveform Recorder Help Table of Contents Foreword 0 2 Part I Contents 1 Safety Instructions ................................................................................................................................... 2 2 Controls ................................................................................................................................... 2 3 Troubleshooting .................................................................................................................
Contents 1 2 Contents Operation Instructions for Velleman PC Oscilloscope PCSU1000 TRANSIENT RECORDER Safety Instructions Controls Troubleshooting Adding comment text in the signal screen 1.1 Safety Instructions SAFETY and WARNINGS ! Important safety information, see user manual. Before making measurements and for safety reasons, it is important to know some information about the measured unit. Safe devices are: · Battery operated equipment · Equipment supplied via a transformer or adapter.
3 Waveform Recorder Help values switch CH1 off. Coupling AC: the input signal is capacitive coupled to the input amplifier/attenuator. Only the AC components are measured. GND: the input signal is broken and the input amplifier/attenuator is connected to earth. Use this position for selecting a reference point on the display. DC: the input signal is directly connected to the input amplifier/attenuator. Both AC and DC voltage are measured.
Contents · · · · · 4 TIME/DIV switch is in the wrong setting, try 1s/div TRIGGER is ON, set TRIGGER OFF The unit input selection is at GND. Y position is wrongly adjusted. Input amplitude is too large, adjust VOLTS/DIV setting. If the above tips have no effect, then test on a different computer or different USB port. Note. Close the program before disconnecting the USB cable. 1.
5 Waveform Recorder Help AutoSave Data Saves all next screens of data in text format to a file. The AutoSave function will be activated after the Run button is pressed. The AutoSave function will be finished after the Run button is pressed again. Note: Every screen saved takes about 20kB of disk space Save Settings Saves the Oscilloscope, Spectrum Analyzer and Transient Recorder settings to a file. Also Function Generator settings (frequency, amplitude, offset and duty cycle) are stored to the file.
Menu opties 6 Two horizontal markers for measuring voltage Note: The voltage markers give preference to channel Ch1 if both channels are being used. Two vertical markers for measuring time Marker function for absolute and relative time measurement is provided. If V & t markers are selected the absolute time of the marker position is displayed. If V & dt markers are selected the time difference between the markers is displayed. Moving the markers 1.Place the mouse pointer over a dashed marker line. 2.
