Manual

PROMIX400U2

V. 02 – 09/03/2012 4 ©Velleman nv

• Always begin with the master faders, volume controls and the amplifier volume at minimum position.

Gradually turn up the volume after connection is completed.

• Use the controls with restraint. Rapid movements may damage the speakers due to amplifier clipping.

• Use the original packaging if the device is to be transported.

• Keep this manual for future reference.

4. Features

• outputs: 2 Master (XLR and RCA), 1 Rec (RCA) and booth monitor output (RCA)

• inputs: 2 Phono (RCA), 4 Line (RCA) and 1 MIC (Combi), USB

• with Digital Signal Processor (DSP) effects and fader start control

• trim: gain for each input channel

• peak level meter: allows the user to instantly determine the source input condition for each channel

• talk over: mutes -14dB all levels apart from the microphone MIC1

• cross fader curve: choose from two types of cross fader start-up options

• headphone monitor balance between cue and master out

• freely assignable long life TCT cross fader (45mm) with adjustable curve

• extra LED display per channel for pre-listening signal

• gain control with 3-fold sound control (+12/-26dB) per channel

• 3-fold sound control (+12/-26dB) for microphone

• CUE on and off switch for each channel

• cue-split function: the cue signal is sent to one side of the headphones and the output-signal to the

other side.

5. Overview

Refer to the illustrations on page 2 of this manual.

1 power switch: turn the mixer on or off.

3-pin XLR connection for main microphone (not included)

MIC LEVEL: adjust the microphone input level

HI/LOW: microphone equalizer

Input channel controls (CH-1 … CH-4)

Input selector switches:

• Channel 1-2: LINE or PHONO. Set to PHONO if a turntable (not incl.) is connected to the input;

otherwise set to LINE.

• Channel 3: LINE or USB. Set to USB if an input device is connected via the USB port [24]; otherwise

set to LINE.

• Channel 4: LINE or MIC. Set to MIC if a microphone (not incl.) is connected to the input; otherwise

set to LINE.

TRIM: adjust the input signal level

HI/MID/LOW: channel equalizer

Peak level meter

Master channel

LED meter: indicates the master output level

TALK OVER: press this button to decrease the sound level for everything other than the main

microphone to 14dB. Press again to restore original status.

CUE: press this button to monitor the channel with headphones. You can select multiple channels at

once, including the master channel and the DSP effects. Press again to cancel the selection.