Owner's manual

PROMIX902 VELLEMAN

b. Back Panel (fig. 2)

24. Ground connector:

With this screw you can connect the ground of the turntables 1-4.

25. Input connectors LINE 1-4:

RCA connectors can be connected to one of the 4 CD / LINE.

26. MASTER outputs:

Unbalanced RCA connectors can be connected to any power amplifier and this output voltage is enough to drive

any power amplifier.

27. RECORD connector:

Stereo output (RCA connectors) to connect with an extensional recorder.

28. Input connectors PHONO 1-4:

RCA connectors can be connected to one of the 4 PHONO.

29. MIC inputs:

1/4” – 6.35mm jacks to connect 1-4 microphones.

30. Fuse holder:

This fuse is to protect the mixer against all kind of AC problems. If the fuse is broken, replace with a new one of

the same range.

31. POWER input:

AC input connector to connect the power cable. Be sure you have the right power supply before plug in the

socket.

6. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.

2. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.

3. Disconnect the device from the mains prior to maintenance activities.

4. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.

5. Contact your dealer for spare parts if necessary.

7. Specifications

Power supply 230VAC / 50Hz

Fuse 20mm fuse 250V 500mA slow (order code: FF0.5N)

Frequency response 10-20.000Hz ± 0.5dB (RLAA ±2dB)

S/N Ratio:

MIC 70dB

PHONO 70dB

CD/LINE 80dB

Micro inputs 1.5mV @ 10kΩ

Line/CD inputs 150mV @ 22kΩ

Phono inputs 3mV @ 47kΩ

Record output 775mV @ 600

Ω

Talk-over max. 200mW / 8 ohms

Tone controls +/-12dB @ 10 kHz / 1Khz / 100Hz