V DIR VTSD IN NFRA-RE ED SMD & BGA RE EWORK STATION S N US SER MANUAL 3
VTSDIR Main station front panel Main station rear panel Figure 21.03.
VTSDIR Use er man nual 1.. Introdu uction To o all residen nts of the European E Un nion Im mportant en nvironmenttal informattion about this t produc ct This symbol s on th he device or the package e indicates th hat disposal of the devic ce after its liffecycle could d harm the environment. Do no ot dispose off the unit (orr batteries) as a unsorted municipal waste; w it shou uld be tak ken to a specialized com mpany for rec cycling.
VTSDIR • • • • The system m can produce a lot off heat. Do not n allow the e IR spot from m the IR hand tool or IR R from the PCB pre-heater, to contact exposed e skin n as burning may occur. To eliminate the possib bility of burns, allow time e for the equipment to co ool before co ommencing maintenance m e. Death or serious s inju ury may res sult from electric shoc ck. It is there efore essenttial to isolate e the equipment from the ma ains before commencing c repairs.
VTSDIR 6. Setup Refer to the illustrations on page 2 of this manual. Note: never unplug any connection during operation. • The equipment must be sited on a firm surface at least 1.2M x 0.75M and at a height to suit the operator. The location should be chosen to suit the flow of work. • Plug the solder light plug into the socket on the front of the main station. • Plug the solder light fan into the cooling fan socket [18] and place the solder light in the holder.
VTSDIR P Preparation n The • • • The • • • procedure for preparing to rew work SMT/BG GA componen nts is as follo ows: Switch h on and warrm up. Set ‘co ontrol setting gs’ required for PCB/com mponent Sort to ools and flux xes required..
VTSDIR • • How long do I preheat the PCB? Always preheat the PCB (up to 120°C or between 45 – 90 seconds) to allow the heat to conduct through to the component before introducing the top heat. With the 700W pre-heater the top of a small PCB will reach 120°C in approximately 45 – 90 seconds. Larger PCBs will take longer to pre-heat. To check the PCB/component temperature, use the hand-held IR temperature sensor to ‘look’ down at the PCB/component from about 60mm away and at about 45° angle.
VTSDIR Appendix 1 Remove screws [X], remove metal bar [Y] and remove plastic tubes [Z]. 21.03.
VTSDIR Place the metal grid and secure it with the two screws [X]. 21.03.
VTSDIR Appendix 2 21.03.
VTSDIR 21.03.
Velleman® Service and Quality Warranty Velleman® has over 35 years of experience in the electronics world and distributes its products in more than 85 countries. All our products fulfil strict quality requirements and legal stipulations in the EU. In order to ensure the quality, our products regularly go through an extra quality check, both by an internal quality department and by specialized external organisations.
