LENS ADAPTER MANUAL LA-MFT-NAF LA-NEX-NG LA-NEX-NF
INTRODUCTION Thank you for choosing a Vello Lens Adapter. Vello lens adapters allow you to use lenses from manufacturers other than the maker of your camera body, so you can mount a lens on a camera body with which it would otherwise be incompatible. Vello Lens Adapters fit securely to the lens, but not so tightly that they are difficult to remove. Please follow these instructions to mount and remove your Vello Lens Adapter.
TO MOUNT THE LENS ADAPTER Note: Place the lens on a stable, flat surface when mounting or removing your Vello Lens Adapter. 1. Line up the red alignment dot on the lens adapter with the alignment line or dot on the lens. 2. Rotate the lens adapter counterclockwise until it locks into place.
TO ADJUST THE APERTURE RING (NEX-NG ONLY) 1. Rotate the aperture ring counterclockwise to open the aperture. 2. Rotate the aperture ring clockwise to close the aperture. Note: For Sony E-mount (NEX) cameras, enable the “Release without Lens” function in the menu of the camera. For Panasonic Micro Four-Thirds (MFT) cameras, enable the “Shoot without Lens” function in the menu of the camera. 3. Line up the alignment dots on the lens adapter and the camera.
TO REMOVE THE LENS ADAPTER 1. Press the lens release button on the camera. 2. Rotate the lens assembly counterclockwise to release.
3. Lift and hold the release pin on the lens adapter. 4. Rotate the lens adapter clockwise to release.
ONE-YEAR LIMITED WARRANTY This VELLO product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after replacement, whichever occurs later.
www.vellogear.com © Copyright 2014 Gradus Group Vello and other names of Vello products are trademarks of Gradus Group. Other product and corporate names mentioned herein are trademarks of their respective holders.
