User's Manual

RCC-N2
RCC-P1
RCC-O2
RCC-N3
RCC-O1
RCC-S1
RCC-C1
RCC-N1
RCC-C2
• There are no user-serviceable parts
inside the devices. Do not attempt to
disassemble or perform any
unauthorized modification.
• Do not operate the FreeWave in the
presence of flammable gas or vapors.
• Do not handle with wet hands or
immerse in or expose to water or
rain. Failure to observe this
precaution could result in fire or
electric shock.
• Keep out of the reach of children.
This device contains small parts which
may pose a choking hazard.
4 17
• Observe caution when handling
batteries. Batteries may leak or
explode if improperly handled. Use
only the batteries listed in this
manual. Make certain to align
batteries with correct polarity.
• Batteries are prone to leakage when
fully discharged. To avoid damage to
the product, be sure to remove the
batteries when leaving the product
unattended for prolonged periods or
when no charge remains.
• Do not use or leave the devices in
conditions of extreme heat, severe
cold, or high humidity.
• Turn o the camera’s power before
inserting or removing the remote
cord.
• Dispose used batteries, packaging, and
old devices in accordance with
appropriate local environmental
regulations.
RCC-C2 – Canon EOS 10D / 20D / 30D / 40D / 50D / 5D / 5D Mark II / 5D Mark III / 7D / 1D / Mark II /
Mark IIn / Mark III /Mark IV / 1DS / Mark II/ Mark III / 1D X
RCC-N1 – Nikon D1 / D1H / D1X / D2 / D2H/ D2Hs / D2X / D2XS / D3 / D3X / D3S / D4 / D200 /
D300 / D300s / D700 / D800 / D800E Fuji S3pro / S5Pro Kodak DCS-14N
RCC-C1 – Canon EOS 30 / 33 / 50 / 60D / 300 / Digital Rebel (300D) / XT (350D) / XTi (400D) / XSi
(450D) / XS (1000D) / T1i (500D) / T2i (550D) / T3 (1100D) / T3i (600D) / Powershot G10 /
G11 / G12 / G1 X Contax N / 645 Pentax K100D / K110D / K200D / K10D / K20D / K-5 /
K-7 / *ist DS / DS2 / DL2 / DL / D Sigma SD1
Samsung GX-1S / GX-1L / GX-10 / GX-20 / NX Series
RCC-S1 – Sony α100 / α200 / α300 / α350 / α500 / α550 / α560 / α580 / α700 / α850 / α900 / SLT α33 /
α35 / α55 / α57 / α65 / α77
RCC-O1 – Olympus E400 /E410 / E420 / E450 /
E510 / E520 / E620 / E-P2 / E-P3 / E-PL2 /
E-PL3 / E-PM1 / SP-510UZ / SP-550UZ /
SP-560UZ / SP-570UZ / XZ-1
RCC-O2 – Olympus E-1/ E-3/ E-5
RCC-N3 – Nikon D70s / D80
RCC-N2 – Nikon D90 / D3100 / D3200 / D5000 /
D5100 / D7000
RCC-P1 – Panasonic DMC-L1 / DMC-L10/ DMC-G1/
DMC-GF1 / DMC-GH1 / DMC-GX1/
DMC-G2 / DMC-GH2 / DMC-G3 /
DMC-G10 / DMC-FZ100 / DMC-FZ150
The FreeWave includes a camera
release cable that enables the remote to
work with certain models of cameras,
but just by changing the camera release
cable, a single FreeWave Receiver can
work with many other cameras as well.
At right are models of Vello Camera
Release Cables for FreeWave and the
cameras they support. For these cables,
and cables for other camera models,
check with your Vello dealer.
SAFETY WARNINGS CAMERA RELEASE CABLES