User's Manual

3
Smart Code: 16,000,000 possible
radio channels. No dip switches to
set. One transmitter can trigger
multiple receivers.
Extended Range: up to 100m
(320 ft.)
Multi-function: Trigger your camera
wirelessly or wired. Wired
triggering works even if the battery
in the receiver is dead or missing.
Versatile: One receiver works with
dozens of camera models. Just swap
out the camera release cable.
KEY FEATURES
18 3
Dual-Function Release: Press
halfway to focus; press full to trigger
shutter.
Delayed Release: Two-second delay
function gives you extra time to get
into position.
Multi-exposure: Take multiple shots
with one press of the trigger.
Long Exposure: Control the length of
the exposure remotely.
LED indicators: Confirm pre-focus
and exposure during wireless mode.
Troubleshooting
Problems with the FreeWave can be
traced to the following most common
causes. Perform the following steps to
diagnose the problem:
• Check that the shutter release cable is
in good condition and is properly
connected.
• Make sure that the Receiver switch
has not been set to Hold.
• Remove the battery from the
Receiver, reinsert it, and reset the
Smart Code.
SPECIFICATIONS | TROUBLESHOOTING
Power
Battery Life
Smart Code Channels
Range
Frequency
Confirmation LEDs
Shutter Modes
Tra nsm it ter
12V / 23A
up to 3 years
Receiver
3V / CR2
approx. 20,000 triggers
16,000,000 possible codes
100m (320 ft) with no obstructions
433 MHz
2 color
single shot, 2-second delay, continuous, & bulb