User's Manual

24
1. With all devices turned o, connect
and secure the receiver to the camera
by plugging the 2.5 mm shutter release
cable into the camera’s shutter remote
port and the other end into the
receiver’s shutter release [ ] output.
2. Turn on the camera,
transmitter, and receiver.
3. Synchronize the channel selection
on the transmitter and receiver.
4. Set your camera to single-shot mode.
5. Half-press the shutter release test
[ ] button on the transmitter
to autofocus the camera.
6. Fully press the shutter release test [ ]
button on the transmitter to activate
the camera’s shutter. A green light will
appear on the transmitter when the signal
is sent, and a red light will appear on the
receiver when the signal is received.
TRIGGERING THE CAMERA | SINGLE-SHOT MODE