User's Manual

25
1. With all devices turned o, connect and
secure the receiver to the camera by
plugging the 2.5 mm shutter release cable
into the camera’s shutter remote port and
the other end into the receiver’s shutter
release [ ] output.
2. Turn on the camera, transmitter, and
receiver.
3. Synchronize the channel selection on the
transmitter and receiver.
4. Set your camera
to continuous
shot mode.
5. Half-press the shutter release test
[ ] button on the transmitter to
autofocus the camera.
6. Fully press and hold the shutter release
test [ ] button on the transmitter
to activate the camera’s shutter. Release
the button to stop the shutter. A green
light will appear on the transmitter when
the signal is sent, and a red light will
appear on the receiver when the signal
is received.
TRIGGERING THE CAMERA | CONTINUOUS-SHOT MODE