User's Manual
26
1. With all devices turned oξ, connect
and secure the receiver to the camera
by plugging the 2.5 mm shutter release
cable into the cameraβs shutter remote
port and the other end into the
receiverβs shutter release [ ] output.
2. Turn on the camera,
transmitter, and receiver.
3. Synchronize the channel selection
on the transmitter and receiver.
4. Set your camera to bulb mode.
5. Half-press the shutter release test
[ ] button on the transmitter
to autofocus the camera.
6. Fully press and hold the shutter release
test [ ] button on the transmitter to
open the cameraβs shutter. A green light
will appear on the transmitter when the
signal is sent, and a red light will appear on
the receiver when the signal is received.
7. Release the button to close the shutter.
TRIGGERING THE CAMERA | BULB MODE