User's Manual

Playing Audio via USB Port

The sound bar automatically switches to USB input mode with the LED display when a USB flash drive

is inserted (this mode isn't selectable on the sound bar or remote control unless a USB flash drive is connected).

1. Ensure that your USB flash drive contains MP3 audio files (other file types not supported)

2. Connect the USB flash drive to the USB port on the sound bar (or your own USB extension cable connected to

the USB port); music will automatically play with LED display “00:00”, when music is played on, the play time will

be automatically displayed on the screen.

3. Press the VOL +/– buttons to adjust the volume to your desired level.

4. During playback:

Start, pause or resume play. Skip to the previous or next track.

Playing Audio via Audio input(Aux)Connection

• Use a 3.5mm to 3.5mm audio cable (not included) to connect the PC, tablet, smartphone, TV’s headphone

socket to the AUX socket on the soundbar.

• Use a RCA to 3.5mm audio cable (included) to connect the Blue Ray DVD Player / TV’s audio output

sockets to the AUX socket on the soundbar.

• Then short-press the button on the sound bar or on the remote controller to switch to audio input

mode with LED display lighting up .

• In this mode, playback can only be controlled on your connected device

Note: For some computer, you may need to access the audio control panel to manually set the soundbar

as above picture.

Optical Mode

Using an optical cable, connect the OPTICAL connector on your Soundbar (Optical digital input) to the

OPTICAL OUT connector on the TV or other device. The TV or other device must have an optical digital output.

Proceed as follows:

• Connect the optical cable to the OPTICAL jack on the rear of the sound bar.

• Connect the other end of the optical cable to audio output jack on TV or other device.

• Set TV to PCM Stereo or Stereo 2.0.

Headphone

AUX

AUDIO OUT