Specifications

Starfire Series Manual
www.chrysalisacoustics.com
6
C ROSSOVERS
F
i
g
u
r
e 2. Starfire-Mini Rear Panel Connections
Receiver/Processor Subwoofer Outputs
T
h
e C
h
rysalis subwoofer is designed to operate using the full range audio signal for input when using the built-in crossover. Many home
theater processors/receivers (Dolby Digital™, DTS™, THX™) have a “subwoofer out” jack (sometimes labeled “LFE”) that is internally filtered,
s
ettable at the receiver/processor, and designed to be used with a powered subwoofer. In some installations, it may be beneficial to use
BOTH the Chrysalis crossover and the receiver/processor crossover, resulting in a steeper ultimate crossover slope. In some rare cases,
combining both an external crossover and the one internal to the subwoofer may result in low output and increased noise. In these
installations you may need to bypass the crossover in either the processor or your Starfire subwoofer, or simply setting one crossover to a
higher frequency (such as 120 Hz) will restore maximum performance.
(Refer to Figure 3 Line-Level Subwoofer Connection Diagram and Figure 4 Speaker-Level Subwoofer Connection Diagram, pages 7 and 8 for
c
o
n
nection diagrams.)
TM