User guide
www.velodyne.com
12 - CHT-Q Series User’s Manual
INTERCONNECT CABLES
When installing your new Velodyne subwoofer using the line level connections, you should always use shielded
phono cables. There are many high quality cables available today. It is recommended that you keep the length
of cable as short as possible to avoid any potential noise problems.
When using speaker level connections, use a high quality speaker cable that mates well with the connectors.
Be very careful to avoid any loose strands or frayed wires that may result in a short, which may damage
yourequipment.Cablesofextremelylargesize arenotrequiredduetothelow currentdrawofthistypeof
connection.Extremelylargegaugewiremaynotproperlytintheterminals,resultinginapoorconnectionand
possible short circuits.
USAGE
This section addresses usage of your CHT-Q subwoofer.
Remote Control
The features of the CHT-Q remote control are listed below.
NOTE: The CHT-Q remote can be attached magnetically to the back of the
subwoofer in the upper left hand corner.
• POWER — This button forces your CHT-Q subwoofer unit into standby
mode.ThewooferwillnotplayandtheLEDwillturno.Theunitwill
remain in this mode until the POWER button is pressed again. To fully
deactivate(i.e.powerdown)theunit,turnothepowerswitchonthe
back panel.
• MUTE — This button mutes the subwoofer’s output. The LED on the sub will show 00 if the unit is
muted. To unmute the subwoofer, press the MUTE button again and the original volume setting shows
on the LED.
• EQ—Thisbuttonautomaticallyequalizesthesubwoofer’soutputsothatitsoundsbestforitsposition
in the room. To use this feature, remove the grille and plug the supplied microphone into the Mic-In jack
onthefrontbaeofthesubandplacethemicinyourpreferredlisteningposition.ThenpressEQonthe
remote for about 2-3 seconds. The subwoofer emits 12 “sweep tones” that span the frequencies between
20and150Hz.TheLEDdisplays“AU”duringtheAuto-EQprocess.Afterthesweepsarecomplete,the
unit saves its EQ settings and returns to normal operation. To prevent accidental invocation of the EQ
feature, you must hold down the EQ button for 2-3 seconds before the EQ sweeps begin. If the mic is
not plugged in, the subwoofer sweeps twice then reverts back to normal functioning without changing
any EQ settings.
• PHASE — These buttons allow you to optimize the subwoofer’s bass performance relative to the
speakers and your listening position. Play some bass heavy music. While listening, push one of the four
phasebuttons,listenforafewmoments,andthenpressthenextphasebutton.Inmostinstallations,
oneofthefourbuttonpositionswilloeranaudiblybetterblendofsubwooferandspeakers.TheLED
will show the phase selected by showing “PH” followed by the phase number: 0, 90, 180 or 270.
Figure 6: EQ-MAX Remote.