User Manual

15
.
www.velodyne.com
Digital Drive User’s Manual
Figure 5: System Settings Screen
From this screen the crossover, subsonic filter, phase, polarity, theater/music, volume, and
other settings can be set, as well as specifics for each preset, if desired.
Your DD unit comes with 6 presets, four of which are preprogrammed at the factory. The
Setup setting is used to initially set the crossovers, slopes, phase, polarity, and volume for all
presets. Then, each preset can be individually adjusted if desired. The presets are as follows
(they are also labeled on the remote):
1. Action/Adventure
2. Movies
3. Pop/Rock
4. Jazz/Classical
5. Custom (off from the factory, or flat)
6. EQ Defeat
All six presets contain the following fields:
• Low Pass Cr
ossover Frequency and Slope – Adjust the upper limit of your subwoofer’s
frequency response. Select a crossover setting, in increments of 1, between 15Hz and
199Hz and slope at 6, 12, 18, 24, 30, 36, 42 and 48 dB/octave.
• Subsonic Filter Fr
equency and Slope – Set your subwoofer’s subsonic filter (low
frequency limit), in increments of 1, between 15Hz – 35Hz and slope at 6, 12, 18, 24,
30, 36, 42 and 48 dB/octave.