Manual

www.velodyne.com
16 - Digital Drive Series User’s Manual
Phase – Set the phase (delay) of the subwoofer’s output signal, 0 to 180 degrees (adjustable in 15
degree increments).
Polarity Set your subwoofer’s polarity by toggling between positive (+) or negative (-). This reverses
the phase 180 degrees.
Volume – Each preset can have its own volume separate from the master volume shown in the setup
column. When the master volume changes, the preset volume changes in lock step.
Contour Frequency – This allows you to set a frequency to boost or cut the signal to your subwoofer
in response to specic types of source material. These have been preset at the factory according to the
presets above, but any or all can be customized to taste.
Contour Level This indicates the amount of boost or cut at the frequency specied in the contour
frequency. Again, this has been preset at the factory but can be adjusted to taste.
Theater/Music Indicator This setting aects the distortion limiting capabilities of the digital servo
system and allows you to choose between a “theatrical” subwoofer, a “musical” subwoofer, or somewhere
in-between. The scale is 1 for maximum theater (least amount of servo gain) and 8 for maximum music
(most amount of servo gain). Other controls on the Setting Setup Screen:
Auto On/O Active/Inactive When active, this control automatically shuts the subwoofer o after
approximately 15 minutes without any source signal. The woofer automatically wakes upon receiving
input signal again.
Night Mode Maximum Volume – When the NIGHT mode button is pressed on the remote, this setting
is invoked. Night mode is indicated by the amber bar underlining the VELODYNE logo. The subwoofer
will not play louder than this volume level until the night mode is defeated.
Light Control This setting determines the status of the Velodyne logo light. The setting defaults to “on.”