User`s manual

Y
our new Velodyne subwoofer provides for a number of installation options. Read all the
installation information below in order to determine which installation option is best suited for
your system.
Remember to perform all installation procedures with system power turned
off to prevent possible damage.
Figure 1. MicroVee Back Panel
Impor
tant!!! Insure that the subwoofer is only connected to the rated source voltage.
Do not connnect the 120-volt version to 230-volts or vice-versa. This will result in
damage to the subwoofer and possible injury to the user.
Inputs
Your new subwoofer is equipped with speaker-level, line-level, and MINI-JACK inputs. Use the
LINE LEVEL jacks when connecting your subwoofer to a pr
e-amp, signal pr
ocessor
, line-level
cr
ossover or receiver with pre-amp level outputs. The
SPEAKER LEVEL jacks connect dir
ectly
to the speaker outputs of any amplifier, integrated amplifier or receiver. Your amplifier section
will notice no additional loading effects when you use these inputs due to their very high
impedance. Use the
MINI-JACK inputs when connecting to a docking station or personal
audio system.
Impor
tant!!! Do not use any of the LINE LEVEL, SPEAKER LEVEL, and
MINI-JACK
connections simultaneously!
3
.
www.velodyne.com
MicroVee User’s Manual
Installation