User`s manual

CARE OF YOUR SUBWOOFER
Do not use any harsh detergents or chemicals to clean the cabinet. Abrasives, detergents, or
cleaning solutions will damage the finish on the cabinet. We recommend using a damp cloth
to clean the front, back and sides.
During normal conditions, the subwoofer may
be left on continuously without any problems.
If you plan to leave the unit unused for an extended period of time, we recommend that you turn
off the subwoofer by the master power switch on the rear panel.
TROUBLESHOOTING AND SERVICE
Before seeking service for your amplifier or subwoofer, please re-check all systems. Following
is a simple troubleshooting guide to assist you.
1. Verify that the unit is plugged in and power outlet used is active.
2.
Is the power switch on?
3.
Is the unit receiving an input signal from your source?
4. Have
all controls on the amplifier (volume, crossover, phase, etc.) been properly set?
5.
If the unit has been running at high levels, one of the protection circuits may be engaged.
Has the amplifier overheated?
6. Has the power button been depressed on
the remote?
7. Make sure binding posts are tightened.
If the protection circuitry is active, the unit may cycle on and off until operating parameters
return to normal. Under more serious conditions, the unit may shut off completely. Normal
operation should
return upon cooling, but you may be required to turn the power off and then
on again to reset the unit.
The following conditions require service
by a qualified technician:
1. The power cord has become damaged
2. The unit does
not appear to operate normally or exhibits a marked
change
in performance
3. The unit has been exposed
to water
4. Some part of the chassis or circuitry is physically damaged
Thank You for Purchasing a Velodyne Optimum Subwoofer!
WWW.VELODYNE.COM
Optimum User's Manual 15