Installation manual

136195-2201
ATS0 – Automatic answer
This S0-parameter controls the automatic answering feature of the mobile.
Application to GSM ATS0=2 Automatic answer after 2 rings
GSM to application OK
Application to GSM ATS0? Current value
GSM to application 002 Always 3 characters with leading
OK zeros
Application to GSM ATS0=0 No automatic answer
GSM to application OK Command valid
All others S-parameters (S6,S7,S8 ...) are not implemented.
+CICB – Incoming Call Bearer
Command syntax: AT+CICB= <mode>
This specific command is used for incoming call type when no incoming bearer is given
(single numbering scheme, see +CSNS).
<mode> values:
0: Data
1: Fax
2: Speech
Application to GSM AT+CICB=1 If no incoming bearer, force a fax
call
GSM to Application OK Command accepted
Application to GSM AT+CICB=2 If no incoming bearer, force a
speech call
GSM to Application OK Command accepted
Application to GSM AT+CICB? Interrogate value
GSM to Application +CICB: 2 Default incoming bearer:
speech call
Application to GSM AT+CICB=? Test command
GSM to Application +CICB: (0-2) Speech, data or fax default
incoming bearer